Ignition Coil Replacement
Special Tools
EN-6009 Remover and Installer Ignition Module
For equivalent regional tools, refer to
Special Tools .
Removal Procedure
1. |
Remove engine sight
shield. |
2. |
Disconnect ignition coil
wiring harness plug (2) from ignition coil (1). |
3. |
Remove the 2 ignition coil
bolts (1). |
4. |
Install EN-6009
remover/installer (1) to ignition coil (2). |
5. |
Remove the ignition
coil. |
Installation Procedure
1. |
Install the ignition
coil. |
2. |
Remove EN-6009
remover (1) from ignition coil (2). |
3. |
Install the 2 ignition coil
bolts (1) and tighten to 8 N·m (71 lb in)
. |
4. |
Connect ignition coil wiring
harness plug (2) to ignition coil (1). |
5. |
Install engine sight
shield. |
|