vauxhall Workshop Repair Guides

Vauxhall Workshop Service and Repair Manuals

Charging System Test > < Starter Noise Diagnosis

DTC B151A

Diagnostic Instructions

•  Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure.
•  Review Strategy Based Diagnosis for an overview of the diagnostic approach.
•  Diagnostic Procedure Instructions provides an overview of each diagnostic category.

DTC Descriptor

DTC B151A 58: Low Battery Capacity Detected

Circuit/System Description

The body control module (BCM) monitors the battery voltage level during an engine crank event to detect a low battery voltage condition.

Conditions for Running the DTC

The vehicle is ON

Conditions for Setting the DTC

A minimum crank battery voltage is less than the minimum crank battery voltage threshold for 16 consecutive crank events.

Action Taken When the DTC Sets

A driver information center (DIC) message is displayed.

Conditions for Clearing the DTC

The DTC will clear if the minimum crank voltage is greater than the minimum crank voltage threshold during a crank event.

Reference Information


Schematic Reference

Starting and Charging Schematics


Connector End View Reference

Component Connector End Views


Description and Operation

Charging System Description and Operation


Electrical Information Reference


Scan Tool Reference

Control Module References for scan tool information

Circuit/System Verification

Before replacing the C1 battery perform the Battery Inspection/Test .

Charging System Test > < Starter Noise Diagnosis