Piston, Connecting Rod, and Bearing Removal
|
Note: Mark the
installation position of the connecting rod bearing caps. The
connecting rod bearings and bearing caps must not be interchanged
with other connecting rods.
|
| 1. |
Remove the 4 connecting rod
bearing cap bolts (1) of cylinder 2 and 3. |
| 2. |
Remove the 2 connecting rod
bearing caps (2) and the 2 connecting rod bearings of cylinder 2
and 3. |
| 3. |
Rotate the crankshaft
180° . |
| 4. |
Remove the 4 connecting rod
bearing cap bolts (1) of cylinder 1 and 4. |
| 5. |
Remove the 2 connecting rod
bearing caps (2) and the 2 connecting rod bearings of cylinder 1
and 4. |
| 6. |
Remove the 4 pistons (1) and
connecting rods (2) and the 4 upper connecting rod bearings (3)
from the cylinder block. |
|
