Turbocharger Removal
Special Tool
EN-49942 Holding Wrench
For equivalent regional tools, refer to
Special Tools .
| 1. |
Install the EN-49942
holding wrench (2) to the turbocharger coolant feed pipe.
Guide a ratchet wrench (1) along with an extension through
EN-49942 holding wrench to the turbocharger coolant
feed pipe hollow screw. |
|
Note: EN-49942 holding wrench (2) should be
installed to turbocharger coolant feed pipe as shown. The holding
wrench should be installed to avoid twist of the turbocharger
coolant feed pipe during the loosening procedure.
|
| 2. |
Loosen the turbocharger
coolant feed pipe hollow screw with ratchet wrench and extension
(1). |
| 3. |
Remove the turbocharger
coolant feed pipe hollow screw (3) and the 2 seal rings (1) and
(2). |
| 4. |
Disconnect the turbocharger
oil return pipe (4) from the engine block. |
| 5. |
Remove the turbocharger oil
feed pipe bolt (5) from the oil cooler. |
| 6. |
Remove the turbocharger oil
feed pipe hollow screw (4) and the 2 seal rings (1) and (3) and
close the screw bore in the turbocharger. |
| 7. |
Remove the turbocharger oil
feed pipe (2) and the rubber seal ring. |
| 8. |
Disconnect the turbocharger
coolant return hose (6) from the oil cooler coolant inlet pipe and
remove the turbocharger coolant return pipe bolt (7) from the oil
cooler. |
| 9. |
Remove the 8 turbocharger nuts
(1). |
| 10. |
Remove the turbocharger
assembly (1) and the turbocharger gasket (2). |
|
