vauxhall Workshop Repair Guides

Vauxhall Workshop Service and Repair Manuals

ABOUT US
Oil Flow Check Valve Replacement > < Engine Oil and Oil Filter Replacement - 1.6L LDE, LXV, 1.8L 2H0, LUW and LFH

Astra J

Camshaft Seal Replacement (1.6L LDE, LXV, 1.8L 2H0, LUW and LFH)

Special Tools

•  EN-422   Installer
•  EN-45000   Remover

For equivalent regional tools, refer to Special Tools .

Removal Procedure

1. Remove the camshaft position actuator adjuster. Refer to Camshaft Position Actuator Adjuster Replacement .

           2191650




Note:  Do not damage the sealing surfaces.
2. Use the EN-45000   remover to loosen the camshaft front oil seals (1).

           2189265



3. Remove the camshaft front oil seals (1).

Installation Procedure


           2189265



1. Insert 2 NEW camshaft front oil seals (1).

           2373396



2. Tighten the seal ring with EN-422   installer (3) on the camshaft until this is in contact with the cylinder head.
3. To install, use camshaft sprocket bolt (1) in conjunction with shims (2) with a total thickness of approximately 10 mm (0.393 in).
4. Install the camshaft position actuator adjuster. Refer to Camshaft Position Actuator Adjuster Replacement .

Oil Flow Check Valve Replacement > < Engine Oil and Oil Filter Replacement - 1.6L LDE, LXV, 1.8L 2H0, LUW and LFH