Drive Belt Installation
Special Tools
EN-6349 Locking Pin
For equivalent regional tools, refer to
Special Tools .
| 1. |
Install the drive belt
(1). |
|
Note: Make sure that
the drive belt is aligned on the generator pulley (4), crankshaft
balancer (5), drive belt tensioner (6) and water pump pulley (7).
The drive belt must lie on the water pump pulley between the flange
(1) and (2).
|
| 2. |
Check the position of the
drive belt (3). |
| 3. |
Release tension to the
tensioner counterclockwise (1). |
|
Note: Allow tensioner
to slide back slowly.
|
| 4. |
Remove EN-6349
pin (2). |
| 5. |
Apply tension to the tensioner
at projection (1) clockwise. |
|
