Piston, Connecting Rod, and Bearing Installation
Special Tools
EN-45059 Torque Angle Sensor Kit
For equivalent regional tools, refer to
Special Tools .
| 1. |
Lubricate the piston rings,
piston, inner cylinder bore surface and a piston ring compressor
with clean engine oil. |
| 2. |
Install the piston ring
compressor in order to compress the piston rings. |
| 3. |
Install the piston and
connecting rod assembly (4). |
| 4. |
Install the connecting rod
bearing (3). |
| 5. |
Install the connecting rod cap
(1). |
| 6. |
Install NEW connecting rod
bolts (2) and tighten to 35 N·m (26 lb ft) +
45° using the EN-45059 sensor kit
. |
| 7. |
Assemble the caps and
connecting rods in the marked position. |
| 8. |
Rotate the crankshaft to a
position where the connecting rod bolts are in the best situation
for install. |
|
