DTC U0020
Diagnostic Instructions
DTC Descriptor
DTC U0020 00: Low Speed CAN Communication
Bus Performance |
Circuit/System Description
Modules connected to the GMLAN serial data circuits monitor for
serial data communications during normal vehicle operation.
Operating information and commands are exchanged among the modules.
The modules have programmed information about what messages are
needed to be exchanged on the serial data circuits. The messages
are also supervised and some periodic messages are used by the
receiver module as an availability indication of the transmitter
module.
DTC U0020 will set when fewer modules are detected on the bus
before the modules can learn the other modules IDs. If the
communication bus is opened, or if the modules power supply is lost
when the vehicle is in the OFF power mode, and then placed in the
RUN power mode, U0020 will set in specific modules.
Conditions for Running the DTCs
• |
Voltage at the modules is in
the normal operating voltage range. |
• |
The vehicle power mode
requires serial data communication to occur. |
• |
The DTC U2100 does not have a
current status. |
Conditions for Setting the DTC
A supervised periodic message that includes the transmitter
module availability has not been received.
Action Taken When the DTCs Sets
The module uses a default value for the missing parameter.
Conditions for Clearing the DTC
• |
A current DTC clears when the
malfunction is no longer present. |
• |
A history DTC clears when the
module ignition cycle counter reaches the reset threshold, without
a repeat of the malfunction. |
Circuit/System Verification
Diagnosis of this DTC is accomplished via the symptom or an
additional DTC, Refer to
Symptoms - Data Communications
DTC U0100-U02FF .
|