Workshop Manuals Factory service & repair Vauxhall
Vauxhall Astra J13 · Power and Signal Distribution
13 · General

DTC U0001

Make
Vauxhall
Model
Astra J
Section
Data Communications › Other Information › DTC U0001
Power and Signal DistributionDTC U0001

DTC U0001

Diagnostic Instructions

•  Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure.
•  Review Strategy Based Diagnosis for an overview of the diagnostic approach.
•  Diagnostic Procedure Instructions provides an overview of each diagnostic category.

DTC Descriptor

DTC U0001 00: High Speed CAN Communication Bus

Circuit Description

Modules connected to the GMLAN serial data circuits monitor for serial data communications on the GMLAN network during normal vehicle operation. Operating information and commands are exchanged among the modules. Each module on GMLAN network maintains a transmit error counter (TEC) and a receive error counter (REC). The counter values increase with detected errors and will decrease with error-free messages. If the TEC value exceeds 255 the controller removes itself from the network and a DTC U0001 will be set.

Conditions for Running the DTC

•  Voltage supplied to the module is in the normal operating voltage range.
•  The vehicle power mode requires serial data communication to occur.

Conditions for Setting the DTC

A certain number of no valid transmitted messages on the GMLAN serial data circuits are detected by the module.

Action Taken When the DTC Sets

•  The module suspends all message transmission.
•  The module uses default values for all parameters received on the GMLAN serial data circuits.
•  The module inhibits the setting of all other GMLAN communication DTCs.

Conditions for Clearing the DTC

•  A current DTC clears when the malfunction is no longer present.
•  A history DTC clears when the module ignition cycle counter reaches the reset threshold, without a repeat of the malfunction.

Diagnostic Aids

•  This DTC cannot be retrieved with a current status. Diagnosis of current DTC is accomplished via the symptom, Scan Tool Does Not Communicate with GMLAN Device. Refer to Scan Tool Does Not Communicate with High Speed GMLAN Device .
•  An intermittent condition is likely to be caused by a short on the GMLAN serial data circuits. Use the Scan Tool Does Not Communicate with GMLAN Device procedure in order to isolate an intermittent condition. Refer to Scan Tool Does Not Communicate with High Speed GMLAN Device .

Reference Information


Schematic Reference

Data Communication Schematics


Connector End View Reference

Component Connector End Views


Description and Operation

Data Link Communications Description and Operation


Electrical Information Reference


Scan Tool References

Control Module References for scan tool information

Parts & tools for this job For Vauxhall Astra

Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.