AFL/EPC Connectors
Special Tools
• |
EL-38125-580
Terminal Release Tool Kit |
• |
J-38125-12A
Terminal Release Tool |
• |
J-38125-216
Terminal Release Tool |
For equivalent regional tools, refer to
Special Tools .
Terminal Removal Procedure
Follow the steps below in order to remove terminals from the
connector.
1. |
For connectors with a bolt in
the dress cover, turn the bolt counterclockwise to remove the
connector from the component. |
2. |
Locate the connector position
assurance (CPA) on the top of the wire dress cover. Slide the CPA
forward. |
3. |
Slide the lever lock forward
while pressing down on the lever lock release tab. |
4. |
View showing depressing of the
lever lock release tab. |
5. |
View of connector in released
position. |
6. |
Disconnect the connector from
the component. |
7. |
Locate the dress cover locking
tabs at the corners of the dress cover. Use a small flat-blade tool
to release the locking tabs and remove the dress cover.
|
8. |
Release the rear lower half of
the wiredress cover. |
9. |
Release the tabs that are
holding the wiredress cover to the connector body. |
10. |
Remove the nose piece by
inserting a small flat-blade tool into the slots on both ends of
the connector body. Gently pry the nose piece out of the connector.
J-38125-216 can also be used to remove the nose piece. |
11. |
Use the J-38125-12A tool to
release the terminals by lifting the terminal retaining tabs on the
inside of the connector. |
12. |
While holding the removal tool
in place, gently pull the wire out of the back of the connector.
Always remember never use force when pulling a terminal out of a
connector. |
14. |
Insert the repaired terminal
back into the cavity. Repeat the diagnostic procedure to verify the
repair and reconnect the connector bodies. |
|