Yazaki Connectors (16-Way)
Special Tools
| • |
EL-38125-580
Terminal Release Tool Kit |
| • |
J-38125-215
Terminal Release Tool |
For equivalent regional tools, refer to
Special Tools .
Terminal Removal Procedure
| 1. |
While depressing the lock,
pull the two connector halves apart. |
|
Note: The terminal
position assurance (TPA) is fragile and may break if not done
carefully.
|
| 2. |
Use a small flat-blade tool to
very carefully push the TPA towards the face of the connector on
both sides of the connector. |
| 3. |
View of the male half of the
connector with female terminals. |
| 4. |
View of the female half of the
connector with male terminals. |
| 5. |
Use the J-38125-215 tool to
release the terminals by inserting the tool into the terminal
release cavity. |
| 6. |
View of the female half of the
connector with male terminals. |
| 7. |
View of the male half of the
connector with female terminals. |
| 8. |
While holding the removal tool
in place, gently pull the wire out of the back of the connector.
Always remember never use force when pulling a terminal out of a
connector. |
| 10. |
Insert the repaired terminal
back into the cavity. Repeat the diagnostic procedure to verify the
repair and reconnect the connector bodies. |
|
