Callout
|
Component Name
|
Preliminary Procedures
|
1
|
Lower Control Arm Rear Bushing Bolt
|
2
|
Lower Control Arm Rear Bushing
Warning: Refer to
Torque-to-Yield Fastener Warning
.
Caution: Refer to
Fastener Caution .
Procedure
|
1. |
Install and hand tighten the NEW bushing bolt. Do
NOT reuse old bolt. |
|
3. |
Support the lower control arm with a hydraulic
jack and lift the control arm into the neutral position. |
|
4. |
Tighten lower control arm bushing bolt. |
Tighten
55 N·m (41 lb ft) + 45 - 60°
Special Tools
EN-45059 Torque Angle Sensor Kit
For equivalent regional tools. Refer to
Special Tools .
|