vauxhall Workshop Repair Guides

Vauxhall Workshop Service and Repair Manuals

ABOUT US
Input and Output Speed Sensor Installation > < Low and Reverse and 1-2-3-4 Clutch Housing Cleaning and Inspection

Astra J

Low and Reverse and 1-2-3-4 Clutch Housing Assemble

Table 1: 1-2-3-4 Clutch Piston Installation
 Table 2: Low and Reverse Clutch Piston Installation

1-2-3-4 Clutch Piston Installation



1891402



1-2-3-4 Clutch Piston Installation


Callout
Component Name

1
1-2-3-4 Clutch Piston

Tip
DT-47798   protector prevents the piston seal lip from damage during installation. Apply a thin coat of ATF to the ID of DT-47798   protector to ease the installation of the piston.

Special Tools

DT-47798   Seal Protector

2
1-2-3-4 Clutch Spring

3
1-2-3-4 Clutch Spring Retainer

Caution: Regulate the air pressure to 276 kPa (40 psi) maximum. High pressure could cause the piston to over travel and damage the piston seals.

Procedure

1. Place the retainer onto DT-47799-1 which is part of DT-47799 compressor . Compressing the spring using DT-47799-2 which is part of DT-47799 compressor , will install the retainer into the retainer groove.
2. Apply shop air to the clutch fluid feed hole in the clutch housing to verify proper piston operation.

Special Tools

DT-47799   Clutch Piston Spring Compressor
 

Low and Reverse Clutch Piston Installation



1891404



Low and Reverse Clutch Piston Installation


Callout
Component Name

1
Low and Reverse Clutch Piston

Tip
DT-47807   protector prevents the piston seal lip from damage during installation. Apply a thin coat of ATF to the ID of DT-47807   protector to ease the installation of the piston.

Special Tools

DT-47807   Clutch Piston Seal Protector

2
Low and Reverse Clutch Spring

3
Low and Reverse Clutch Spring Retainer

Caution: Regulate the air pressure to 276 kPa (40 psi) maximum. High pressure could cause the piston to over travel and damage the piston seals.

Procedure

1. Place the retainer onto DT-47794-1 which is part of DT-47794 compressor . Compressing the spring using DT-47794-2 which is part of DT-47794 compressor , will install the retainer into the retainer groove.
2. Apply shop air to the clutch fluid feed hole in the clutch housing to verify proper piston operation.

Special Tools

DT-47794   Spring Compressor
 

Input and Output Speed Sensor Installation > < Low and Reverse and 1-2-3-4 Clutch Housing Cleaning and Inspection