Manual Transmission Shift Lever and Selector Lever Cable
Adjustment
Special Tools
DT-527-A Adjuster
For equivalent regional tools, refer to
Special Tools .
Removal Procedure
| 2. |
Clip instrument panel lower
center compartment liner (2) out of front floor console using a
suitable plastic tool (3). |
| 3. |
Unlock shift lever and
selector lever cable adjust locks (1), by pushing back the spring
force loaded black sliding ring until self-locking. |
| 4. |
Unlock the left cable trough
the opening at the housing (arrow) using a suitable tool.
|
| 5. |
Slide transmission control
lever boot upwards. |
| 6. |
Press 2 latches
(arrows). |
| 7. |
Slide blue transmission
control lever retainer ring (1) upwards. |
| 8. |
Pull trigger (2)
upwards. |
| 9. |
Remove transmission control
lever knob. |
| 10. |
Turn transmission control
lever knob (1) 180° and install to transmission control
lever. |
| 11. |
Push the 2 pins (2) have to
engage into the 2 holes (3). |
| 12. |
Remove engine control module
from battery tray and lay aside. |
| 13. |
Block transmission control
housing (2) using DT-527-A adjuster (1).
|
Installation Procedure
| 1. |
Lock shift lever and selector
lever cable adjust locks. |
|
Note: When locking
the adjuster locks (1) a defined snap noise should be audible / a
snap effect should be felt.
|
| 2. |
Lock shift lever and selector
lever cable adjust locks. |
| 3. |
Lock shift lever and selector
lever cable adjust locks (1), by pushing down the two blue locking
pieces WITHOUT touching/preloading the fixed shift lever.
|
| 4. |
Install transmission control
lever knob. |
| |
Turn the transmission control lever knob back 180°. |
| 5. |
Press the transmission control
lever knob during installation completely down. Push trigger (2)
upwards. |
| 6. |
Slide blue transmission
control lever retainer ring (1) downwards. |
| 7. |
Remove DT-527-A
adjuster from transmission control housing. |
| 8. |
Check correct shifting
function. |
| 9. |
If necessary repeat adjusting
procedure. |
| 10. |
Clip instrument panel lower
center compartment liner (2) into front floor console. |
|
