Brake Drum, Precision Turn
After removing brake drum, it
can be finely ground if necessary.
Note that the processing
equipment authorized by Customer Service is to be used for this work.
Grinding is done according to
the instructions enclosed with the equipment.
Use brake linings 5.6 mm/0.22
in. thick if brake drum has been reground.
|
Before
installing brake drum, ensure that adjustment pinion is turned back to stop.
The pinion must not lock firmly at end of
adjustment unit.
Install
brake drum.
Position brake drum on wheel hub so that hole for
detent screw aligns with hole in wheel hub.
Mount
rear wheel.
Before mounting rear wheel, thinly coat entire
circumference of collar on wheel hub with antifriction bearing grease.
Lower
vehicle.
|
|
|
Adjust
rear wheel brake.
Operate
service brake - at least 15 times - until jumping of adjustment lever (B)
on adjustment pinion (A) can no longer be heard on either brake drum.
Raise
vehicle and adjust parking brake.
Vehicles
with Catalytic Converter:
Install
heat shield.
|
|
