Vauxhall Workshop Service and Repair Manuals

Crankshaft Front Seal Ring, Replace (16 DA/17 D)

Remove clutch.

See corresponding operation in Group K.

Remove flywheel.

See corresponding operation in this group.

Remove

The seal ring is pulled out of its seating using KM-469-A.

Insert Remover Hook KM-469-6 between sealing lip and crankshaft bearing Journal.

Insert Support KM-469-4 into Lever KM-469-13-A as shown in illustration and lock with Pin KM-328-8.

Insert Lever and Support into crankshaft bearing journal opposite Remover Hook.

Fasten Remover Hook in long slot of Lever and pull out seal ring in direction of arrow.

Install

Coat seal lip of new crankshaft seal ring with protective grease Catalogue No. 19 48 814 (90 001804).

Press Protective Sleeve KM-511-9 into seal ring.

Place protective sleeve with crankshaft seal ring on crankshaft bearing Journal and press in until flush.

Place Pressure Ring KM-511-10 on shaft seal ring.

Press crankshaft seal ring Into cylinder block until snugly seated using Retaining Plate KM- 51 1-1 1 with Hex Bolt KM - 469 -12 - A.

To do this, insert centering pins - arrows - infastening holes of thrust bearing guide sleeve.

Install flywheel and clutch.

Observe prescribed torque. See Table at end of this group.