Valve
Guide, Ream
Remove
cylinder head.
See corresponding operation.
Remove
valves.
See
operation "Cylinder Head, Disassemble and Assemble".
Measure
valve guide with dial gauge and internal measuring instrument.
Attention: Oversize valves may
already be factory-installed.
|
|
Oversize
valve guides are marked directly on the guides and oversize valves are marked
on the stem end with the following identification numbers/letters.
Size Special Identification
Tool Factory Service
Normal without K
0.075 KM-664-1 1 K
1
0.150 KM-664-2 2 K
2
See
also Technical Data at the end of this group.
|
|
Ream
valve guide up to next oversize.
Valve
guides should always be reamed from upper side of cylinder head so that more
precise bore is on cone side.
After
reaming a valve guide, scratch out now invalid identification marks and stamp
in new size.
Install
valves.
Install
cylinder head.
See
corresponding operations.