vauxhall Workshop Repair Guides

Vauxhall Workshop Service and Repair Manuals

Warnings, Disclaimers, Safety > < Idle speed adjustment of 17 D engines with MT; screwing in of Checking Adapter KM- 690

Mechanically Controlled Fuel Injection system

 

Identification / Data               Engine                      17 D                                          17 D

 

Fuel injection pump                                                     Bosch                                        Lucas CAV

 

                                 with MT                                      VE 4/9 F 2300 R 313                DPC OP 02

                                 with AT                                       VE 4/9 2300 R 313/1

 

Filter                                                                             F3/DBS 1 WG/124                  F3/DBS 1 WG/124

 

Injection nozzle                                                            DN OSD 292                            BDN OSD C 6751 C

                                                                                                                                       RDN OSD C 6751 C

 

Opening pressure

                                 new                                             135 + 8 bar                                135 + 8 bar

                                 in run                                           130 + 8 bar                                130 + 8 bar

 

Identification                                                                130                                            130

 

Start of feed at idle speed                                            2° to 4° BTDC                           2° to 4° BTDC

 

Static start of feed BTDC                                             0,80 + 0,05*                              X + 0,15 mm **

 

Lower idle speed in rpm                                              820 to 880                                 820 to 880

 

Upper idle speed in rpm                                              5600 - 100                                 5600 - 100

 

Pre-heater system, voltage in Volt                               12 V                                          12 V

 

Relay                                                                            90 196 015                                90 196 015

 

Glow plug                                                                    90 201 005                                90 201 005

 

*)         Adjustment and checking must take place when engine is cold (room temperature)

**)       X = Individual pump adjustment value printed on pump lever

 

 

 

 

Warnings, Disclaimers, Safety > < Idle speed adjustment of 17 D engines with MT; screwing in of Checking Adapter KM- 690