vauxhall Workshop Repair Guides

Vauxhall Workshop Service and Repair Manuals

Checking with TECH 1 > < Checking Equipment

Abbreviations, Definitions

 

 

BATTERY VOLTAGE          = Battery voltage

 

IGNITION CODING            = Coding of exhaust gas variants (Sweden vehicles)

 

EXHAUST CODING            = Coding of exhaust gas variants (US '83 or ECR 15.04) via wiring harness

 

TRANSM. CODING             = Coding of transmission variants (MT or AT) via wiring harness

 

MASS AIR FLOW S.            = Signal from mass air flow sensor hot-wire

 

IDLE CO POT.                      = Idle CO potentiometer

 

IDLE POSITION SW.           = Information about throttle valve switch idle contact

 

FULL POSITION SW           = Information about throttle valve switch full load contact

 

COOLANT TEMP.               = Coolant temperature

 

ENGINE LOAD SIG.           = Electronic engine load signal in ms calculated from air flow sensor signal

 

INJECTION PULSE             = Opening time of injection valves in ms

 

ENGINE SPEED                   = Engine speed

 

SPARK ADVANCE              = Spark advance

 

TORQUE CONTROL           = Engine torque on automatic vehicles is reduced via the ignition during shifting

 

KNOCK RTD. CYL.1    ü

KNOCK RTD. CYL.2    î    = Ignition timing adjustment of individual cylinders when knocking occurs

KNOCK RTD. CYL.3    ì

KNOCK RTD. CYL.4    þ

 

PARK/NEUTRAL SW.         = Information about the selecter lever switch on automatic vehicles and simultaneous coding of transmission variants

 

IAC PULSE RATIO              = Pulse duty factor of idle speed adjuster

 

IAC INTEGRATOR               = Integrator value idle speed adjuster

 

IAC BLOCK LEARN            = Idle speed adjuster pattern recognition value

 

OPEN/CLOSED LOOP        = Open/closed control circuit via oxygen sensor

 

O2 SENSOR                          = Oxygen sensor voltage

 

O2 INTEGRATOR                = Integrator value for correction of mixture (02)

 

O2 BLOCK LEARN 1          = Block learn mixture characteristic curve correction value 1

 

O2 BLOCK LEARN 2          = Block learn mixture characteristic curve correction value 2

 

PHASE SENSOR                  = Hall sensor on high tension distributor

 

A/C INFORMAT.SW.           = Air conditioning switch

 

A/C COMPRESS.SW.          = Air conditioning compressor

 

ENG. OIL TEMP. SW          = Engine oil temperature switch (not occupied at present)

 

TRAN.OIL TEMP.SW          = Transmission fluid temperature switch (not occupied at present)

 

MAF                                       = Hot-wire, Mass Air Flow sensor

 

ECU                                       = Electronic Control Unit

 

Master Cartridge                    = Program Module

 

TECH 1 Self-Test Routine     = TECH 1 Self-Test

 

Checking with TECH 1 > < Checking Equipment