Vauxhall Workshop Service and Repair Manuals

Checking Equipment

TECH 1 Case containing:

· TECH 1

· Connecting Cable

· Checking Adapter for TECH 1 (Self-test)

· Operating Instructions

Program Module "OPEL 88-89 ECU"

The Program Module "OPEL 88-89 ECU" contains the software for checking

Multec C 13 N, C 16 NZ, E 16 NZ

Motronic M 1.5, M 2.5, ML 4.1

Electronic MSTS with self-diagnosis

Electronic 4-speed automatic AW 03-71 LE

Electronic 4-speed automatic AR 25/35

Electronic 4-speed automatic AF 14/20

Board computer

Four wheel drive 4x4

Delivery range with language version

Catalogue

No.Part No.

DEUTSCH/FRANCAIS/ITALIANO

17 56 135

90 349 228

FRANCAIS/NEDERLANDS/ENGLISH

17 56 136

90 349 229

ESPANOL/DANSK/ENGLISH

17 56 137

90 349 230

SVENSKA/NORSK/SUOMI

17 56 138

90 349 232

Electronic Kit I, KM-609

A measurement connection to link up the information sensors fitted in the vehicle can be made using the relevant plugs and sockets together with the cables of Electronic Kit I.

The MOTRONIC information sensors can then be checked with the engine running.

Diagnostic Switch KM-640

For handling of blink code readout on vehicles as of Model Year 1987 see section 5.3.1.

Pressure Gauge KM-7-34730-1

The pressure gauge is for checking the fuel pressure in the injection system. It is connected by a special threaded connection to a valve on the intake manifold.

Note:

Before connecting or removing, all pressure is to be released from the system.

After connection, the hose line between the intake manifold and the pressure gauge must be bled to avoid incorrect measurements.

A bleeding hose with hand valve is part of the pressure gauge.

Multimeter MKM-587-A

The Multimeter is a multi-purpose instrument for measuring voltage, current and resistance. The values measured are displayed digitally.

The Opel Tester can also be used instead of the Multimeter.

Checking Spark Plug

The checking spark plug is required for checking the ignition system.

For this purpose it is connected to cable 4.

Checking Lamp KM-602-1

The checking lamp is needed to check the injection system.

For this purpose it is connected to the plugs of the individual injection valves.