vauxhall Workshop Repair Guides

Vauxhall Workshop Service and Repair Manuals

F0: Data List - Test Steps 15 to 18 KNOCK RETARD CYL. 1 to 4 > < F0: Data List - Test Step 13 SPARK ADVANCE

 

 

 

 

 

Test

TECH 1

Notes

Nominal Values

Possible

Step

Display

 

 

Trouble

No.

 

 

 

Codes

 

 

 

 

 

 

 

 

 

 

14

TORQUE CONTROL

Ignition ON

INACTIVE    5 V

 

 

 

Engine at idle speed

INACTIVE    5 V

75

 

 

Automatic vehicle driving

 

 

 

 

and using automatic shift

ACTIVE         0 V

 

 

 

 

 

 

 

 

Note

 

On vehicles with AT the engine torque is reduced during shifting via the pre-ignition.

If trouble code 75 is stored and the actual value display does not correspond with the nominal values on vehicles with AT, then the transmission does not shift automatically any more but must be shifted by hand.

In driving stage "D", the transmission remains in 4th gear only.

Before disconnecting the transmission control unit make sure that trouble codes were read out and noted.

 

Trouble-shooting:                                 Nominal Value:                       Cause of Fault:

(If nominal value is not attained)

Ignition OFF

· Disconnect transmission                                                                                                   · Interruption in cable from Motronic control

control unit from wiring harness                                                                                           unit Ter. 51 to transmission control unit Ter. 13

 

· Measure voltage at transmission                                                                                     · Short circuit against ground in cable

control unit plug Ter. 13                                                                                                      from Motronic control unit Ter. 51 to

using multimeter                                                                                                                    transmission control unit Ter. 13

· Motronic control unit defective

Ignition ON                                                            > 4.9 V

 

· Place Ter. 13 on transmission control             Trouble code 75                                 · Motronic control unit defective

unit plug against ground.

 

Start engine

 

Read out fault memory                                      Trouble code 75

 

· Measure voltage at transmission                      9.5 to 10.5 V                                          · Interruption or short to ground from

control unit plug Ter. 29                                    (dependent on                                       Motronic control unit Ter. 6 to

with engine running                                           engine speed)                                        transmission control unit Ter. 29.

using multimeter

· Motronic control unit defective

 

If nominal values are attained --->   · Transmission control unit defective

 


Related Literature Units
-Table 2 - Trouble Code Table: Trouble Code 75

F0: Data List - Test Steps 15 to 18 KNOCK RETARD CYL. 1 to 4 > < F0: Data List - Test Step 13 SPARK ADVANCE