vauxhall Workshop Repair Guides

Vauxhall Workshop Service and Repair Manuals

Table 5 - Test Step 03 FUEL TANK VENT. > < Table 5 - Test Step 01 IDLE AIR CONTROL

 

 

 

 

 

Test

TECH 1

Notes

Nominal Values

Possible

Step

Display

 

 

Trouble

No.

 

 

 

Codes

 

 

 

 

 

 

 

 

 

 

02

Injection valve 1,

A defect in the injector

-

25, 26, 27,

 

2, 3 or 4

circuit affects the

 

81, 82, 83,

 

TEST FAILED!

mixture correction values,

 

 

 

 

see also test steps 25, 26, 27

 

 

 

 

F0:DATA LIST

 

 

 

 

 

 

 

 

 

Trouble-shooting:                                 Nominal Value:                       Cause of Fault:

(If nominal value is not attained)

 

Ignition ON

 

· Measure voltage at                                             11.5 to 13.5 V                                        · Lead interruptions from control unit Ter. 37

- Control unit Ter. 37                                                                                                           or from fuel pump relay Ter. 87

- Injection valve plug Ter. 1                                                                                               to injection valve

 

· Remove wiring harness strip from                  Ckecking lamp flashes                       · Interruption or short circuit to ground in

all 4 injection valves on                                     on all cables                                            cable from

all injection plug cables                                     when engine is started                          - Injection valve cyl. 1 to control unit Ter. 17

- Injection valve cyl. 2 to control unit Ter. 34

Connect Checking Lamp KM 602-1 to all                                                                         - Injection valve cyl. 3 to control unit Ter. 16

injection plug cables one after                                                                                           - Injection valve cyl. 4 to control unit Ter. 35

the other and start engine

· Control unit defective

 

If nominal values are attained ----->· Injection valve defective

Injection valve resistance value

at room temperature : approx. 16 Ohm

 


Related Literature Units
-F0: Data List - Test Step 25 O2 INTEGRATOR
-
-
-
-

Table 5 - Test Step 03 FUEL TANK VENT. > < Table 5 - Test Step 01 IDLE AIR CONTROL