Astra
|
General Instructions/Safety Precautions
When using Diagnostic Switch KM-640 only stored Trouble Codes can be read out. This takes place with the help of the engine telltale in the instrument panel of the vehicle.
Readout of data using TECH 1 takes place with IGNITION ON or with the engine operating. During correspondence between TECH 1 and the mixture system control unit, the appropriate telltale flickers dully. This indicates an exchange of data between TECH 1 and the control unit.
To erase Trouble Code: With TECH 1: press key F4 Without TECH 1: ignition off and disconnect ground from battery for at least 1 minute.
Safety Measures:
· The ground lead is to be disconnected from the battery during work where there is danger of a short circuit.
· At temperatures over +80 °C/+176 °F (drying oven), control units must be removed.
· Never connect or disconnect wiring harness plugs of control units or trigger boxes with ignition on.
· Before charging or quick-charging, disconnect the battery from the vehicle electrical system.
· Never use the quick-charger for starting.
· Caution when touching voltage-bearing parts of the ignition system!
IMPORTANT: After connecting the battery clock board computer electronic window winders radio receiver (coding) should be reprogrammed if necessary.
|
