vauxhall Workshop Repair Guides

Vauxhall Workshop Service and Repair Manuals

F0:Data List - Test Step 29 TC TPS LOAD SIG > < F0:Data List - Test Step 27 ENGINE SPEED

F0:DATA LIST

 

 

No.

TECH 1 Display

Conditions for Checking

Nominal Value

Trouble Codes

Terminal

28

PARK/NEUTRAL SW.

Vehicles with automatic transmission AF 22 and Motronic M 2.8

 

Ignition ON

Engine OFF

Apply parking brake

Selector lever in "P" or "N"

Selector lever in "R", "D", "3", "2", "1"

 

 

 

 

 

 

 

 

ACTIVE       0V

 

INACTIVE  12V

59

11, 35

Trouble-shooting:

Nominal Value:

Cause of Fault:

(If nominal value is not attained)

·   Carry out test step nos. 09, 11, 12, 13 and 14

 

OK

 

·   Carry out trouble-shooting as specified in test step no. 09

 

·   Ignition ON

·   Selector lever in position "D"

·   Using TECH 1, select test step no. 28:

 

 

 

INACTIVE      12V

 

 

 

·   Short circuit to ground

from:      transmission control unit wiring harness plug Ter. 11

to:          engine control unit wiring harness plug Ter. 42

·   Transmission control unit defective.

 

 

Note:

The following measurements are made with the wiring harness plug connected. Wiring harness plug terminal 11 is connected to ground from the rear, the wiring harness side, using the probes from Electronic Kit KM-609.

 

 

 

 

·   Bridge transmission control unit wiring harness plug:

from:      transmission control unit wiring harness plug Ter. 11

to:          ground, Ter. 31

ACTIVE           0V

 

·   Short circuit to voltage

from:      transmission control unit wiring harness plug Ter. 11

to:          engine control unit wiring harness plug Ter. 42

·   Transmission control unit defective.

 

 

If nominal values are attained

 

·   Circuit interruption

from:      transmission control unit wiring harness plug Ter. 11

to:          engine control unit wiring harness plug Ter. 42

·   Engine control unit defective.

 

 

 

 


Related Literature Units
-F0:Data List - Test Step 09 SELECTOR POS.
-
-
-
-
-

F0:Data List - Test Step 29 TC TPS LOAD SIG > < F0:Data List - Test Step 27 ENGINE SPEED