· The voltage level recognized by control unit at the
relevant control unit output is Low (0 V),although control unit output was
set at High (12 V; solenoid valve is not actuated)
(short circuit
to ground)
· With
ignition ON the fault is immediately recognized.
· If the
fault appears after the engine is started, it is only recognized after the
solenoid valve is actuated.
If
trouble code 26 was recognized, the following gears are still shifted in the
following driving stages
(emergency
program):
Automatic
Transmission AF 14 / 20:
"Driving
stage" (gear): "D" (4), "3" (3), "2" (3),
"1" (1)
Automatic
Transmission AF 13 / 22:
"Driving
stage" (gear): "D" (4), "3" (4), "2" (3),
"1" (1)
|