Vauxhall Workshop Service and Repair Manuals

Cover and/or Gasket for Brake Band Assembly Servo Piston, Replace

Raise vehicle.

Unscrew fluid pan (16 screws).

Note:    Only loosen screws "A".

              Place suitable receptacle under pan to collect fluid.

Tilt fluid pan so that fluid can flow out over edge "B".

Remove remaining 2 screws.

Remove fluid pan with gasket. Gasket must not be reused.

Loosen screw on retainer (1) and remove fluid filter with gasket (stuck on).

Unscrew cover for brake band assembly servo piston (4 screws) and remove along with retainer (1).

Remove gasket. Gasket must not be reused.

Install cover for brake band assembly servo piston with new gasket and tighten - torque 11 Nm/8.11 lbf. ft.

Note: Install retainer (1) as well.

Install fluid filter with gasket and tighten retainer torque 24 Nm/17.7 lbf. ft.

Install fluid pan with new gasket and tighten with 16 screws torque 11 Nm/8.11 lbf. ft.

Lower vehicle.

Correct transmission fluid level - see operation "Transmission Fluid Level, Check and Correct" in this group.