|
Selector Lever Cable,
Replace
Remove selector lever cable
at selector lever on transmission.
Note: To do this, remove snap ring.
Unscrew selector lever cable
at retainer and remove.
|
|
|
Remove cover (1) from
console and from selector lever.
|
|
|
Remove shift gate (1) with
shift slot cover (2) and lift off over selector lever.
Note: Before
removing, detach plug for shift gate
lighting.
|
|
|
Loosen screw fitting (1) on
clamp for selector lever cable.
Unscrew and detach selector
lever cable on base plate (2).
Connect cable to
pull-through coil and pull out of bulkhead through engine compartment.
|
|
Connect new cable to
pull-through coil and pull in.
Note: Make sure that protective cover is correctly seated
in bulkhead.
Align selector lever cable
free of tension in base plate and tighten.
Screw on selector lever cable
to retainer in engine compartment and tighten.
Connect selector lever cable
to transmission selector lever and secure with snap ring.
Adjust selector lever cable -
see operation in this group.
Install shift gate with cover,
reconnecting plug for shift gate lighting.
Note: Adjust selector lever scale of shift gate to match
white marking on cover.
Replace cover on console.
