Vauxhall Workshop Service and Repair Manuals

Governor and/or Seal Ring, Replace

Remove cover for governor (2 screws) and remove along with O-ring.

O-ring must not be reused.

Note:    Make sure that needle bearing between governor cover and speedometer driving gear is not lost.

Remove speedometer driving gear (1) from governor.

Remove governor (2) from governor housing. O-ring on governor shaft must not be reused.

Install new O-ring on governor shaft.

Insert governor with speedometer driving gear and needle bearing.

Install new O-ring in governor cover and screw governor cover on tight (2 screws) - torque 11 Nm/8.11 lbf. ft.