|
Cover and/or Seal Ring
for Governor,
Replace
Unscrew union nut on
speedometer cable and remove speedometer cable from governor.
Note: On
vehicles with LCD instrument or board computer the wiring harness plug for
odometer frequency sensor must be unplugged.
Unscrew cover for governor
(2 screws) and remove along with O-ring. O-ring must not be reused.
Note: Make
sure that needle bearing between governor cover and speedometer driving gear
is not lost.
Install new O-ring in
governor cover and screw governor cover on tight (2 screws) - torque 11
Nm/8.11 lbf. ft.
Note: On
vehicles with LCD instrument or board computer plug for odometer frequency
sensor must be connected.
Screw speedometer cable onto
governor.
|
