Vauxhall Workshop Service and Repair Manuals

Seal Rings on Turbine Shaft, Replace

Remove 3 seal rings from turbine shaft (long shank).

Install seal ring on turbine shaft shank using Tool KM-J-29829. Slide seal ring over part "A" into groove "X".

Remove tool.

Note:    On transmissions up to Model Year '82 use only Tool KM-J-29829, part "A". Seal ring must be slid on by hand only.

Note:    On transmissions as of Model Year '82 Tool KM-J-29829, part "B" must be used for installing seal rings.

Fit seal ring in groove using Tool KM-J-29829, part "B".

Note:    Replace the two seal rings on short shank of turbine shaft analogously. Use Tool KM-J-29569 to install seal rings.