Remove and Disassemble End Shield with Mainshaft and Drive Shaft - 4-Speed Manual Transmission
|
End Shield with Mainshaft and Drive Shaft, Remove and Disassemble - 4-Speed Manual Transmission.
Unbolt end shield from main case.
Pull end shield with main shaft and turbine shaft from main case and bolt to Installer KM-552.
Knock 3 plugs for shift detent out of end shield using KM-457-A in conjunction with KM-328-B.
Drive retaining pins out of 3rd and 4th gear shift fork and reverse gear shift fork using punch.
Remove shift rods and shift forks for 3rd and 4th gears and reverse gear from end shield.
Remove both snap rings for fastening main shaft and turbine shaft from end shield using KM-443-A.
Withdraw main shaft and turbine shaft, reverse idler gear and shift fork with shift rod for 1st and 2nd gears from end shield.
|
