|
Rubber
Cap for Gearshift Lever Control, Replace
Remove
gearshift lever and damping element (see operation in this group).
Illus.
B 2322 shows gearshift lever on vehicles without catalytic converter.
Knock
gearshift lever knob off gearshift lever.
Pull
off or destroy rubber cap.
Remove
O-ring from gearshift lever and replace with a new ring.
Pull
on new rubber cap as far as stop.
Beforehand, apply a soap solution to knob of reverse
gear block.
Knock
new gearshift lever knob onto gearshift lever.
Preheat knob in a water bath to 80 °C/176 °F.
With
gearshift lever for vehicles without catalytic converter:
Note position of gearshift lever knob in relation to
hole in knob of reverse gear block.
Install
gearshift lever and damping element (see operation in this group).
|
