|
V-Belt
for Fluid Pump, Replace
Remove
Release
tension of V-belt.
Loosen two bolts (A) for both fluid pump brackets at
main bracket.
Loosen
bolt (B) for tensioning screw on fluid pump and bolt (C) for tensioner on
main bracket.
|
|
|
Loosen nut and lock nut of tensioning screw.
Remove
and replace V-belt.
Note:
On vehicles with 16 SV or C 16 LZ engine (as of
March 1987) the ribbed V-belt runs additionally via the alternator.
To
release the belt, tensioning screw and both alternator retainer bracket
screws must be loosened.
|
|
Install
Position and tension new
V-belt.
Check V-belt tension using
KM-128-A.
See Technical Data for nominal belt tension values
for new and run-in V-belts.
Tighten all bolts previously
loosened (A, B and C - illus. B 9619) - observe prescribed torque.
Retighten V-belt if necessary.
Note:
On vehicles with 16 SV or C 16 LZ engine, tension ribbed
V-belt using torque wrench in conjunction with KM-612.
For nominal value see Technical Data.
