Loudspeakers
- Rear (Two), Install
Models
33, 34, 43, 44
(Not
GSi/GTE and RHD)
Position
loudspeakers left and right on luggage compartment covering
|
|
Loosen
and turn up right front rear quarter inner trim panel. To do this, pull off
flange covering and lower bracket "A". Bracket "B"
remains installed. Remove right hand sill trim. Loosen right rear quarter
inner trim panel or flange covering for rear wheel housing.
|
|
Loosen
and turn up left front rear quarter inner trim panel. To do this, pull off
flange covering and lower bracket "A". Bracket "B"
remains installed. Remove left sill trim. Loosen left rear quarter inner trim
panel or flange covering from rear wheel housing.
|
|
Lay
loudspeaker leads through right and left rear quarter panels, along sill
panels to radio/speaker control and fasten.
Up
to Model Year 1989:
Insert
loudspeakers, bolt in with 2 bolts and connect electrically.
As
of Model Year 1989:
Bolt
on loudspeaker with 4 bolts and connect electrically.
Reinstall
parts removed.
|
|
(Only
GSi/GTE and RHD)
Position
loudspeakers left and right on luggage compartment covering.
|
|
Loosen
and turn up left front rear quarter panel inner trim panel. To do this, pull
off flange covering and lower bracket "A". Bracket "B"
remains installed.
|
|
Connect
loudspeaker leads to loudspeaker wiring harness and lay loudspeaker leads to
radio/speaker control and fasten.
To
do this, connect 4 loudspeaker cables to multiple plug.
Ensure
correct connection of cables.
A =
Left loudspeaker + (identif. colour "red")
B =
Left loudspeaker -
C =
Right loudspeaker + (identif. colour "red")
D =
Right loudspeaker
|
|
Up
to Model Year 1989:
Insert
loudspeaker, bolt on with 2 bolts and connect electrically with present
loudspeaker cables.
As
of Model Year 1989:
Bolt
on loudspeaker with 4 bolts and connect electrically.
Reinstall
parts removed.
|
|
Models
39, 49
Position
loudspeakers left and right on hat shelf.
Loosen
left front rear quarter inner trim panel and turn up forwards.
To
do this, pull off lower bracket. Remove left sill panel.
|
|
Loosen
left rear quarter inner trim panel or flange covering from rear wheel
housing.
Partly
remove flange covering for opening to luggage compartment and unclip lower
part of hat shelf from rear end panel.
Lay
loudspeaker leads along left sill panel to radio/speaker control installation
point and fasten.
|
|
Remove
prepunched openings for loudspeakers from upper rear end panel.
Cut
out openings in hat shelf accordingly.
|
|
Drill
4 holes for loudspeaker attachment in hat shelf. Pre-drill bore holes from
below Æ 2.5 mm/0.1 in.
Holes
already present in upper rear panel.
Then
drill out Æ 4.0 mm/0.10 in. holes in hat shelf.
Important: Do not drill out holes in rear end panel.
|
|
Place
cover for loudspeaker on underside of upper rear panel.
Closed
side points towards rear of vehicle.
|
|
Connect
loudspeaker lead to loudspeaker.
Insert
4 spacers between hat shelf and upper rear panel.
Shorten
spacers according to distance between hat shelf and upper rear panel.
Place
loudspeaker in opening and fasten with Allen bolts.
Reinstall
removed parts.
|
|
Models
35, 36, 45, 46
Position
loudspeakers left and right in tail gate.
Remove
tail gate inner trim panel.
|
|
Loosen
right front rear quarter inner trim panel and turn up forwards.
To
do this, pull off lower bracket.
Remove
right sill panel.
Loosen
right rear quarter inner trim panel or sill seal from rear wheel housing.
Screw
right and left loudspeaker brackets to tail gate.
|
|
Lay
loudspeaker lead through existing rubber grommet in right quarter panel,
along sill panel to radio/speaker control and fasten.
|
|
Connect
and screw in loudspeakers.
Reinstall
parts removed.
|
|
|