· Engine
running for at least 40 s
· Coolant
temperature higher than 75 °C/167 °F
· Throttle
valve opening greater than 0 %
· Following
trouble codes not stored: 21, 22, 33, 34
· The
fault is recognised by the control unit if the oxygen sensor voltage is in
the range from 343 to 540 mV for longer than 20 s
(circuit interruption, oxygen sensor defective).
Replacement value:
· 450 mV
Effect:
· Oxygen
sensor regulation is switched off, i.e. open oxygen sensor loop
Note:
Oxygen sensor must not be wrapped in aluminium foil. Remove
foil.
Then erase trouble code. If trouble code 13 is set again, start
trouble- shooting according to F0:Data List no. 27.
|