Vauxhall Workshop Service and Repair Manuals

Adjustment Regulations for Tapered Roller Bearing (Differential) (F 10/F 15)  

  Adjust   

Maintain the specified torques for bearing pretension by screwing in bearing ring at 1 rev/sec. F 10, F 15: Torsiometer MKM-536-A with KM-455-A  

	Repair case	Transmission removed slip torque (Ncm)	Transmission installed slip torque (Ncm)
		-	-
1)	Adjustment acc. to mark (without axial play). Re-use of all removed parts	(Position bearing ring on mark)	(Position bearing ring on mark)
2)	Adjustment acc. to mark (without axial play). Re-use of all removed parts	60 up to 100	Total slip torque plus 80 1)
3)	Reusing bearing, replacement of bearing ring, bearing flange, differential or transmission housing.	60 up to 100	60 up to 100
4)	Bearing as new part	150 up to 210	150 up to 210

1)  If repaired 2) with transmission installed: position bearing ring on mark, measure total slip torque (with transmission gearset) and additionally adjust to specified value. For all other repair cases, measure without transmission gearset (end shield removed).