Bearing Rings in Transmission Casing, Replace (F 10/F 15)
 Remove, Disconnect Drive out needle sleeve for drive shaft bearing from transmission housing with KM-454-1 and KM-454-4 (transmission removed). With installed transmission, use KM-556-A.
 Important! This operation is only required for replacement of the needle sleeve.
Remove, Disconnect | 
|
Remove roller bushing for main shaft bearing with KM-556-A or Kukko Remover 21/4 with Counterhold 22-1 (transmission removed).
Important! This operation is only necessary when replacing the roller bushing. The differential must be removed - see operation "Differential, Remove and Disassemble". | 
|
 Install, Connect Immerse all parts in transmission fluid before installation. Drive in new roller bushing for main shaft bearing flush with KM-454-3 and KM-454-4. | 
|
Drive in new needle sleeve for drive shaft bearing flush with KM-454-2 and KM-454-4.
Important! Needle sleeve side with writing points to inside of transmission. | 
|
|
