|
Brake Disc, Check for Runout
 Remove
| 1. |
Remove relevant wheel
| • |
Mark position in relation to centre of wheel
|
| • |
Bring transmission into "neutral" position
|
|
| 2. |
Fasten brake disc with two wheel bolts and one 10 mm thick spacing washer respectively
| • |
Attach Dial Gauge MKM-571-B (2) with
magnetic base (1) to spring strut support tube or rear axle
body
|
| • |
Position probe of dial gauge on outer edge of brake disc (3)
with a little pretensioning
Note: See
illustration
|
|
|
|
| 3. |
Rotate brake disc at least one turn. Permitted lateral runout
max. 0.1 mm
|
| 4. |
Remove brake disc and check contact surfaces
Note: If lateral runout
is greater than specified:
- Replace front brake disc
- Replace rear brake disc
| • |
Check wheel hub for runout
- Measure tilt play
- Measure lateral and radial runout
- Rear wheel hub for vehicles with disc brake
|
|
Install
| 5. |
Remove Dial Gauge MKM-571-B with
magnetic base
|
| 6. |
Detach wheel bolts with spacing washers
|
| 7. |
Fit relevant wheel. Tightening torque 110 Nm / 81 lbf. ft.
|
|
