Vauxhall Workshop Service and Repair Manuals > Corsa C > J Engine and Engine Aggregates | DOHC diesel engine | Engine Damping Block | Repair Instructions

Rear Reaction Member (Assembly), Replace

Remove

1.	Open bonnet

Important: On vehicles as of model year 04 with ESP - every time the battery is disconnected, the steering angle sensor loses its basic setting. It must be recalibrated.
2.	Disconnect battery

3.	Raise vehicle

Remove rear reaction member (assembly)

•	Unscrew 3x bolts (1 and 2) Note: Note differing bolts.

Install

Install rear reaction member (assembly)

•	Tighten 2 new bolts (1) 80 Nm + 45° - 60°

•	Tighten bolt (2) 80 Nm

6.	Lower vehicle

7.	Connect battery

8.	Program volatile memory

9.	Close bonnet

Vauxhall Workshop Service and Repair Manuals