Remove and install oil pan (Z 12 XE, Z 12 XEP, Z
14 XEP, with air conditioning, LHD)
Remove
3. |
Remove ribbed V-belt cover
|
4. |
Drain engine oil
• |
Place collecting basin underneath.
|
|
|
|
5. |
Loosen exhaust system
Note: When removing the
centre muffler, a catalytic converter, an exhaust manifold, or an
exhaust manifold with catalytic converter, secure that portion of
the exhaust system remaining on the vehicle against uncontrolled
suspension.
• |
For this purpose, the exhaust system portion including the
flexpipe may be fastened to the vehicle underbody using suitable
means, e.g. wire.
Note: Angular
dislocations of the flexpipe as small as 5 to 10 degrees offset
from the intended installation position can already cause damage
and subsequent complete failure of the flexpipe.
|
• |
Detach oxygen sensor (catalytic converter control) cable
harness plug (1)
|
• |
Detach exhaust system
– |
2 damper rings (arrows)
|
|
• |
Detach front exhaust pipe (2)
|
• |
Suspend front exhaust pipe from left front axle body
|
|
|
|
6. |
Install engine oil drain bolt
|
7. |
Remove oil pan
• |
Crankshaft bearing bridge
|
|
|
|
Install
8. |
Clean sealing surfaces
• |
Crankshaft bearing bridge, oil pan
|
|
9. |
Attach oil pan
• |
Screw in 19 bolts
Note: Note tightening
sequence.
|
• |
On crankshaft bearing bridge
|
|
10. |
Attach exhaust system
• |
Connect oxygen sensor (catalytic converter control) wiring
harness plug.
|
|
11. |
Install ribbed V-belt cover
|
13. |
Top up engine oil
• |
Start engine and allow to run until oil pressure telltale
extinguishes.
|
• |
Check engine oil level, if necessary correct.
|
|
|