vauxhall Workshop Repair Guides

Vauxhall Workshop Service and Repair Manuals

ABOUT US
Replace mixture regulation oxygen sensor > < Replace pre-heating system control unit

Corsa D

Remove and throttle valve module

  Remove

1.   Open bonnet
2.   Remove battery tray
3.   Detach charge air pipe (1) from throttle valve module (3)
•   Unscrew 2x bolts (2)
4.   Detach charge air pipe (1)
•   Detach hose clamp from transmission
– Unscrew bolt
Object Number: 10680814 Size: DEFAULT


5.   Remove throttle valve module (1)
•   Disconnect wiring harness connector (2)
•   Unscrew 3x bolts (3)
•   Unscrew bolt for wiring harness bracket (arrow)
Object Number: 10677357 Size: DEFAULT


  Install

6.   Install throttle valve module
•   Replace gasket
•   Tighten bolt, wiring harness bracket
•   Tighten 3x bolt 8 Nm
•   Connect wiring harness plug
7.   Fit charge air pipe at throttle valve module
•   Replace gasket
•   Tighten 2x bolt 8 Nm
8.   Fasten charge air pipe
•   Attach hose clamp to transmission
– Tighten bolt
9.   Install battery holder
10.   Close bonnet

Replace mixture regulation oxygen sensor > < Replace pre-heating system control unit