Replacing the trailer device control unit or the
Flex Fix System control unit L68
Remove
2. |
Remove the rear-seat back (single unit)
|
3. |
Remove lower tailgate inner panelling
|
4. |
Remove the inner panelling of the C-pillar
|
5. |
Open the service flap (1), side wall panelling
|
6. |
Remove tyre inflation system (2)
• |
Disconnect wiring harness connector.
|
|
|
|
7. |
Detach striker pins (1), rear-seat back
|
|
|
|
8. |
Detach side wall panelling (1)
|
|
9. |
Remove control unit
• |
Remove control unit (1) from bracket
– |
Release retaining lug (2)
|
|
• |
Disconnect 2 wiring harness plugs (3)
|
|
|
|
Install
10. |
Fit control unit
• |
Connect 2x wiring harness plug
|
• |
Insert control unit in bracket
|
|
11. |
Attach side wall panelling
• |
Tighten 3x bolts
Note: Ensure correct
seating of tailgate rubber seal.
|
|
12. |
Attach striker pins, rear-seat back
|
13. |
Close service flap, side wall panelling
|
14. |
Install the inner panelling of the C-pillar
|
15. |
Install lower tailgate inner panelling
|
16. |
Install the rear-seat back (single unit)
|
18. |
Program volatile memories
|
|