Replacing the trailer device control unit or the
Flex Fix System control unit L08
Remove
2. |
Remove luggage compartment mat
|
3. |
Fold down rear-seat back
|
4. |
Remove lower tailgate inner panelling (2)
• |
If present, unclip panel (1), Flex Fix System operating
handle
|
|
|
|
5. |
Release C-pillar panelling (1)
• |
Unclip airbag panel (2)
|
• |
Undo 2 clips and remove from guide
|
• |
Leave C-pillar panelling hanging on belt (3)
|
|
|
|
6. |
Open the side wall panelling service flap
|
7. |
Detach striker pins (1), rear-seat back
|
|
|
|
8. |
Detach rear side-wall panelling
• |
Unscrew 2 bolts (arrows)
|
• |
Disconnect wiring harness connector.
|
|
|
9. |
Remove control unit
• |
Remove control unit (1) from bracket
– |
Release retaining lug (2)
|
|
• |
Disconnect 2 wiring harness plugs (3)
|
|
|
|
Install
10. |
Fit control unit
• |
Connect 2x wiring harness plug
|
• |
Insert control unit in bracket
|
|
11. |
Attach rear side-wall panelling
• |
Fix wiring harness plug
|
|
12. |
Attach striker pins, rear-seat back
|
13. |
Attach service flap, side-wall panelling
|
14. |
Attach C-pillar panelling
|
15. |
Install lower tailgate inner panelling
• |
If present, clip in panel, Flex Fix System operating handle
|
|
16. |
Set rear-seat back into starting position
|
17. |
Insert luggage compartment mat
|
19. |
Program volatile memories
|
|