|
Remove transmission and clutch - see operation "Manual
Transmission, Remove and Install (Vehicles with V6 Engines)" and
"Thrust Plate and Clutch Disk, Remove and Install (without SAC)" in
group "K".
Remove crankshaft needle bearing from crankshaft with KM-328-B
(1).
Install
Coat crankshaft needle bearing with lubricating grease (brown)
and drive into crankshaft using KM-235-D (2).
Check transmission drive shaft for wear.
Install transmission and clutch - see operation "Thrust Plate
and Clutch Disk, Remove and Install (without SAC)" and "Manual
Transmission, Remove and Install (Vehicles with V6 Engines)" in
group "K".
|
