vauxhall Workshop Repair Guides

Vauxhall Workshop Service and Repair Manuals

F8: ECU CONTROL - No. 01 SELECT CONTROL RPM CONTROL > < Table 7, F7: PROGRAMMING

F7: PROGRAMMING

 

No.

TECH 1-Display

Conditions for Checking

Nominal Value

Trouble Codes

Terminal

 

01

SELECT PROGRAM. INIT. ECU

Ignition ON

 

Engine OFF

 

When asked whether the correct control unit is installed, proceed according to the following information:

 

 

 

 

 

 

At present, the Omega - B with the X 25 XE engine is equipped with the following control unit:

Opel Part No.:                          90457097

Alpha Code:                             PR

EXISTING ECU

PART - NO / AC

XXXXXXX / XX

OKAY?

 

INIT. - CODING

F0: RESET

F1: CHANCE

 

 

 

 

 

The Omega - B with the X 30 XE engine is equipped with the following control unit at present:

Opel Part No.:                   90457098

Alpha Code:                      PS

 

 

 

 

 

 

If the question is answered with "YES", TECH 1 shows the sub - menu on the right:

INIT. - CODING

F0: RESET

F1: CHANCE

 

 

 

 

 

Selection of the menu item F0: RESET programs the control unit with the basic application.

Note that, among other adjustments, this resets the idle speed to its basic values. Therefore, if the F0: RESET function is used for an already programmed control unit or adjusted engine, then call up the following TECH 1 function and make / check the relevant adjustment:

Table 6 F6: ECU ADJUSTMENT, test step 01

 

Note:

 

Menu item F1: Change is intended for later applications.

 

INIT. - CODING

F0: RESET

 

 

 

 

 

If the display on the right appears after programming is completed, programming was successful.

PROGRAMMING ECU INIT. - CODING SUCCESSFUL!

 

 

 

 

 

If the display on the right appears after programming is completed, a fault has occurred during programming. Carry out the following measures consecutively:

·   Repeat programming;

·   Carry out TECH 1 self - test;

·   Check TECH 1 cable for damaged insulation and shielding;

·   Repeat programming with new Motronic control unit

PROGRAMMING ECU INIT. - CODING FAILED!

 

 

 

Notes on Trouble - shooting:

Nominal Value:

Cause of Fault:

 

·   See F0: DATA LIST, test steps 45 to 56

·   See Table 1; ALDL Diagnostic Plug, Voltage Supply and Auxiliary Fan for Electronics Box, Check Test steps 1 to 10

 

 

 

 

 

 

F8: ECU CONTROL - No. 01 SELECT CONTROL RPM CONTROL > < Table 7, F7: PROGRAMMING