|
· After
the engine is started, the fault is recognized when the relevant solenoid
valve is switched
· The
voltage level recognized by the control unit at the relevant control unit
output (terminal 38) is 0 V, although the output from the control unit
was set to 12 V (solenoid valve is not actuated) (short circuit to
ground)
Effects:
· Solenoid
valves (brake band, 1 - 2 / 3 - 4 shifting, 2 -
3 shifting, torque converter clutch) and electrohydraulic pressure
regulator are switched off
· If
the fault is recognized, the following gears can still be shifted manually in
each driving stage (emergency program):
"Driving stage"
(gear) "D"(4), "3"(4), "2"(3), "1"(1)
Note:
If trouble code 29 has TC
NOT PRESENT status and trouble code 62 is set, first check the
relevant solenoid valve for the fault
|
