|
No.
|
TECH 1 Display
|
Conditions for
Checking
|
Nominal Value
|
Trouble Codes
|
Terminal
|
|
|
32
|
C.MIRROR H.MOTOR
|
Ignition ON
Set driver's/ co-driver's outside mirror switch to
co-driver
|
|
20
|
13,
25
26-pin
plug
|
|
|
|
|
Outside mirror vertical/ horizontal rocker switch not
actuated
|
INACTIVE
|
|
|
|
|
|
|
Actuate outside mirror vertical/ horizontal rocker switch
until the parameter C.MIRROR H. POS. indicates
high percentage values and the motor has moved to the relevant end stop.
Press one personal key and hold down while the mirror moves
to the stored position
|
RIGHT
|
|
|
|
|
|
|
Actuate outside mirror vertical/ horizontal rocker switch
until the parameter C.MIRROR H. POS. indicates
low percentage values and the motor has moved to the relevant end stop.
Press one personal key and hold down while the mirror moves
to the stored position
|
LEFT
|
|
|
|
|
|
|
|
|
|
|
|
|
Notes on Trouble-shooting:
|
Nominal Value:
|
Cause of fault:
(If nominal value is not
attained)
|
|
If outside mirror adjustment is not possible
· Eliminate fault in driver outside
mirror circuit according to section 5.5. Then proceed with the following
trouble-shooting if necessary
|
|
|
|
|
· Separate wiring harness connection X12,
body/ co-driver's door (bayonet catch)
· Ignition ON
· Carry out F5:ACTUATOR TEST, test step 3
· During check, measure voltage in wiring
harness coupling X12 between Ter. 20 and Ter. 3 using multimeter
|
higher than 10 V
|
· Interruption between X12 and 26-pin
wiring harness plug for control unit K103
|
|
|
· Ignition OFF
· Remove mirror adjustment switch S68
from driver's door handle
· Release 9-pin wiring harness connection
for mirror adjustment switch and separate
· Set driver's/ co-driver's outside
mirror switch to co-driver
|
|
|
|
|
· Using multimeter, measure resistance in
9-pin wiring harness coupling
|
|
|
|
|
between
Ter. 2 and Ter. 5, pressing outside mirror horizontal/ vertical
rocker switch to the right
|
lower than 2 W
|
· Lead interruption or mirror adjustment
switch S68 defective
|
|
|
between
Ter. 2 and Ter. 6 , pressing outside mirror horizontal/ vertical
rocker switch to the left
|
lower than
2 W
|
· Lead interruption or mirror adjustment
switch S68 defective
|
|
|
· Install mirror adjustment switch again
|
|
|
|
|
· Ignition OFF, disconnect battery
negative terminal
· Remove driver's seat
· Release 26-pin wiring harness plug from
control unit and disconnect
· Using multimeter, measure resistance in
26-pin wiring harness plug between Ter. 25 and Ter. 13
|
50 W - 80 W
|
· Interruption in co-driver's door wiring
harness between wiring harness plug X12 and motor M31.1 for co-driver's
outside mirror
|
|
|
Further possible faults:
|
|
· Control unit K103 defective
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
