Brake Hose - Front, Left or Right, Remove and Install Correct brake fluid level up to "MAX" marking and seal with Dummy Screw Cap MKM-558-10.
 Remove, Disconnect Remove front wheel. Unbolt brake line (1) from brake hose - collect escaping brake fluid and close off openings. Detach retaining plates (2). Unscrew banjo bolt (3). Remove brake hose from mount. | 
|
 Install, Connect Insert brake hose in brackets and insert locking plates - ensure that brake hose is not installed twisted. Attach brake line to brake pressure hose. Attach banjo bolt with new seal rings to brake calliper. Remove dummy screw cap from brake fluid reservoir. Attach front wheel.
 Tighten (Torque) Brake line to brake pressure hose - 16 Nm / 12 lbf. ft. Banjo bolt to brake calliper - 40 Nm / 30 lbf. ft. Wheel to wheel hub - 110 Nm / 81 lbf. ft.
 Inspect Bleed brake system bleed and check for leaks - see operation "Brake System, Bleed and Check for Leaks".
|
