Engine Management System EDC MSA 15.6 / EDC 15 M
Crankshaft Pulse Pick-up, Remove and Install
Remove, Disconnect
Remove engine cover.
Disconnect wiring harness plug (1) for crankshaft pulse pick-up and unclip from bracket - place cable aside.
Remove crankshaft pulse pick-up from cylinder block.
Install, Connect
Attach crankshaft pulse pick-up to cylinder block with new seal ring - tightening torque 8 Nm / 6 lbf. ft.
Clip wiring harness plug into bracket and connect - note cable routing.
Install engine cover.