Remove front toothed belt cover - see operation "Front Toothed Belt Cover, Remove and Install".
Inspect
At fastening bolt of toothed belt drive gear, turn crankshaft slowly and smoothly in direction of engine rotation to mark (2).
At the same time, the notches on the camshaft pulleys must be flush with the marks (1) on the cylinder head cover - it must be possible to install the camshaft pulleys in this position with KM-853. If the valve timing can not be set correctly - see operation "Timing, Adjust".
Install, Connect
Install front toothed belt cover - see operation "Front Toothed Belt Cover, Remove and Install".
Remove, Disconnect 
Inspect 
Install, Connect 